Ashcroft ATE-2 - Handheld Calibrator Instrukcja Użytkownika Pobierz pdf (Strona 77)

SECTION 16 b. TROUBLE SHOOTING CONT.

available. If the 2nd module functions properly consult the factory

about the faulty module if both modules fail consult the factory

regarding the HHC base unit.

WILL NOT DISPLAY TEMPERATURE MODULE DATA

For both Thermocouple and RTD modules, ensure that the

module is connected to either a thermocouple or RTD probe and

that the sections of the manual relating to their set up has been

observed .

Follow the procedure for lack of pressure module readings under

“HHC WILL NOT DISPLAY PRESSURE MODULE DATA” above

SYSTEM ERROR MESSAGES

Internal Operating System Error Messages

If any of the following messages are displayed Reset the power

off and back on.

If cycling power does not resolve the issue, note the sequence

of operations performed before the error message appeared and

contact customer service.

Error message list:

• Operation timed out triggering self-protection reset

• Failed to create internal message queue

• Nonexistent notice or error message received

• A system error occurred, and the error message was

corrupted

• Failed to initialize display subsystem

• Failed to initialize ADC subsystem

• Failed to initialize module subsystem

• Failed to initialize keypad subsystem

• Failed to initialize periodic checks subsystem

• Failed to initialize director subsystem

• Failed to initialize MENU subsystem

• Failed to initialize communications subsystem

• Failed to initialize datalog subsystem

• Stack overﬂow in error handling subsystem

• Stack overﬂow in display subsystem

• Stack overﬂow in ADC subsystem

• Stack overﬂow in module subsystem

• Stack overﬂow in keypad subsystem

• Stack overﬂow in periodic checks subsystem

• Stack overﬂow in director subsystem

• Stack overﬂow in MENU subsystem

• Stack overﬂow in communications subsystem

• Stack overﬂow in datalog subsystem

• Stack overﬂow in unknown subsystem

Internal Hardware System Errors

• Internal communication failure (I2C bus)

• Communication failure with module EEPROM

Corrective action: Conﬁrm Module(s) are inserted properly.

Reset power off/on;

If problem persists contact customer service

• ADC reference not within valid range

• ADC conversion timed out

Corrective action: Reset power off/on, contact customer service

• System EEPROM appears to be corrupted

Corrective action: Reset power off/on, contact customer service

Hardware Warnings

• CH1 F.S. INVALID/ CH2 F.S. INVALID:

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 85 86

Komentarze do niniejszej Instrukcji

Brak uwag

Ashcroft ATE-2 - Handheld Calibrator Instrukcja Użytkownika Strona 77

Komentarze do niniejszej Instrukcji